Communication over Radio Frequency has many advantages as it doesn’t require a line of sight connection between the transmitter and receiver as in case of Infrared communication.

The range of RF communication is very high when compared to IR communication. In this project, a wireless transmitter and receiver system using RF modules (RF Transmitter and RF Receiver) is implemented.

An RF Transmitter and Receiver pair is used for wireless communication. The wireless data transmission is done using 433 MHz Radio Frequency signals that are modulated using Amplitude Shift Keying (ASK) Modulation technique.

Circuit Diagram

The circuit is divided into transmitter and receiver sections. The transmitter section consists of an RF Transmitter, encoder IC and four push buttons.

The receiver section consists of RF Receiver, Decoder IC and four LEDs. An extra LED is connected to VT (Valid Transmission) pin of the decoder IC. This is used to indicate a successful transmission of data.

A  resistor is connected between the oscillator terminals of encoder IC. This is to enable the oscillator.
Similarly, another resistor is connected between the oscillator pins of decoder IC.

Component Description

RF Transmitter and Receiver Modules: The wireless communication between transmitter and receiver sections is achieved using RF modules. A 433 MHz transmitter and receiver pair are used in this project.

Working

The aim of this project is to implement a wireless transmitter and receiver using RF modules. It uses radio signals to transmit the data. 

The transmitter and receiver sections are placed at a distance of at least 20 meters. In order to show the working of wireless communication between transmitter and receiver, 4 LEDs at receiver side are controlled by 4 buttons at transmitter section.

The encoder IC converts the 4-bit data from the 4 data pins that are connected to buttons into serial data. This serial data is sent to RF transmitter. The RF transmitter transmits this serial data using radio signals.

At the receiver side, the RF receiver receives the serial data. This serial data is sent to decoder IC which converts into 4 bit parallel data.

The 4 data pins of decoder are connected to LEDs. According to the buttons pushed, the LEDs can be turned ON or OFF.

Applications

*As RF Modules doesn’t require line of sight communication, the transmitter and receiver can be isolated over a distance and data can be transmitted successfully.

*The wireless transmitter and receiver can be used in car door and garage door controllers.

*They can also be used in home automation systems.